40 cm PETG RC Jet Kart Builder Kit – Hull, Pump & Hardware
40 cm PETG RC Jet Kart Builder Kit – Hull, Pump & Hardware
Builder kit · 400 mm hull / 15.7 in
Included: Unassembled PETG hull, printed pump housing, PETG-CF impeller, drive shaft, bearings, screws and related hardware.
You will need: Compatible motor, ESC, steering servo, radio transmitter and receiver, boat battery, charger, assembly and finishing supplies.
Assembly required. Check the included parts and additional equipment before ordering.
Couldn't load pickup availability
Free US shipping · Excludes Alaska & Hawaii
Build your own compact jet kart around a 40 cm printed hull and water-jet pump. This hardware-inclusive kit is for hobbyists who enjoy assembly and choosing their own electronics.
In the kit
Unassembled PETG hull, printed pump housing and PETG-CF impeller, drive shaft, bearings, screws and related hardware.
Required to complete
Motor, ESC, steering servo, radio transmitter and receiver, boat battery, suitable charger, and assembly and finishing supplies are not included. Check component fit before selecting your electronics.
Assembly and finish
The hull is approximately 40 cm (15.7 in) long. The kit ships unassembled. Printed layer lines and small surface imperfections are normal; sanding, finishing, sealing and assembly are required. Finished-boat photos illustrate the design and do not mean an assembled boat or installed electronics are supplied.
This is a builder kit, not a ready-to-run boat. Completed performance depends on your chosen components and assembly.
Free shipping to the contiguous United States.
Product safety information
WARNING: This product can expose you to chemicals including phthalates (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
